Hand Press Die Round Tube Punch Adapter with Anvil ø 8 mm
Product code:
3993-Cu
In Stock 96 pcs
The adapter with anvil for press #3990-00 is designed to hold hole punches #3231-00 and #3231-17. With this adapter, the press can punch holes as well as set hardware. Holes come out precise, and the work goes faster than with a hammer.
- Easy to set up: Place the copper anvil in the bottom of the press, mount the punch holder on top, and tighten the screws with a wrench. Then just screw in the punch in the size you need and you’re ready to go.
- Straight guidance and even pressure: No more crooked holes, just clean openings exactly where you want them. Every piece in a batch looks the same, whether you’re making three belts or thirty collars.
- Saves time: Faster workflow, cleaner results, and a quiet workshop instead of constant hammer blows.
Special note: The punches themselves are not included and must be purchased separately. This adapter is designed for use with punches #3231-00 or #3231-17, which are best suited for punching leather. For #70 Z rivet holes (both 8 and 13 mm), take punch #3231-12 for the adapter, then set the rivet with piston #3997-70 Z.
If you need to punch our waterproof webbings, we recommend using punches #211700STP-6 together with the adapter #21-1700-HMA-set.
Blog post: Riveting by using a hand press
We'll let you know when it's back
Enter your email and we'll send you one notification when this product is back in stock. Nothing more.
