Go to content | Go to main menu | Go to search
You are here: Pet Hardware Horse Hardware Bridle Buckles Bridle buckle – Brass
When you need your bridle to stay exactly how you set it – even if your horse decides to roll in the mud or a proper downpour hits. The bridle buckle is the tried-and-true solution that works reliably where you just can’t count on hook-and-loop or plastic. And it’s just as handy for smaller collars, whenever you want a fastening that’s solid, precise, and stays put for the long haul.
Of course, it’s not Formula 1 – this buckle isn’t the fastest, but if you care most about reliability and precision, you know why you’re choosing it.
Pro tip: When picking a buckle, check both the webbing width and the pin diameter. The buckle should sit flat, and the pin needs to fit the hole without tearing up the leather or webbing.
TIP: Brass naturally oxidizes and darkens over time – it’s not a defect, just the metal reacting with air. You can restore its shine with #SITOL300G paste. To prevent darkening, apply the clear lacquer #637005/GLOSSY.
The force at which the part breaks in a direct-pull test. A reference figure for selection. How to use the breaking load
Cast brass does not form red rust and holds up outdoors in rain and mud
Polished brass develops a patina that pairs well with natural leather
Five sizes from 13 to 32 mm, for bridles, collars and thin straps
Length stays where you set it, with no loosening even when a horse pulls
The bridle buckle is the first place on a finished bridle or collar where I can tell whether I picked the right metal. Where the strap rubs against the frame day after day, I eventually wear through the plating and rust starts underneath. So for a halter, a bridle or a working harness that lives in sweat and rain I use the cast stainless steel bridle buckle, which has no plating at all. The nickel-plated one welded from steel wire or cast in zinc I keep for pieces that stay dry. The brass one ages best, because under the wear there is only more brass, but after years of pull its prong bends and the buckle gets harder to undo. For a small dog’s collar I reach for the low, light stamped stainless steel bridle buckle, so the dog is not carrying a weight around its neck.
Most mistakes, though, happen at the strap. In the fold around the bar the leather lies doubled, so I skive it there; otherwise the buckle sticks out and will not lie flat. I punch the prong hole with an oblong punch and size it to the prong, not to the width of the buckle, because prongs differ even between buckles of the same width. And on a halter I put the buckle underneath, not on the nose, where its weight drags the noseband down.
Enter your email and we'll send you one notification when this product is back in stock. Nothing more.
You've signed up for back in stock notifications. We'll let you know as soon as this item is available again.