Single Cap Rivet – Antique Brass (1000 pcs)

Product code: 75 O - AB
In Stock 106 packs
Two-part saddlery rivet with bite (a very useful notch near the tip of the stem) that will speed up the riveting process, primarily for belts, collars and harnesses, and increase the strength of the join. Single cap rivets are used in places where only one side of the rivet is visible (belts, trunks, flap closure leather bags, … ). The price listed is for the entire package (1000 pcs).

To set using the #3990-00 hand press, use the #3997-72 O die. For hand setting, the #8101-72 Z setter is used.

How to chose the correct-length rivet?

Whether we work with leather, webbing or fabric, the thickness of the material is always the deciding factor. For the rivet to spread properly, choose one that is about 2–3 mm longer than the total thickness of the material. For rivet length see dimension "B" in the table.
Product code 75 O - AB
Material Steel
Surface finish Antique brass Why the shade may vary
Weight 1342 g

Blog post: Riveting guide

Product variants and parameters
13 mm 4 mm 12 mm 1000
Dimensions may vary by ±10%

Enter a quantity to see the total price incl. 21% VAT

Total for 1 pack 43.81 €

Added!

  • 1

    Base price from 1 pack 43.82 €/1000 pcs

  • 5

    Package price from 5 packs 25.04 €/1000 pcs 43% cheaper per pack

  • 20

    Carton price from 20 packs 22.54 €/1000 pcs 49% cheaper per pack Lowest price per pack

About us Hardware, leather and tools under one roof. For collars, leashes, halters, belts and handbags.

Why buy from Pet Hardware®

We'll let you know when it's back

Enter your email and we'll send you one notification when this product is back in stock. Nothing more.

Frequently asked questions

Yes, the smallest quantity is one bag of rivets or 100 snaps. We don't offer smaller packs.

  • Rivets and Chicago screws are sold in bags. Most bags contain 100 pcs, bags of rhinestone rivets also 50 pcs, and bags of eyelets and cap rivets usually 1,000 pcs. Brass and stainless steel Chicago screws and some double cap rivets also come in bags of 10.

  • Snap fasteners and button studs are sold individually, from 100 pcs of one type.

The number of pieces per bag and the price per piece are shown on each product. We'll send you a sample to try. See Can I get a product sample?

The total thickness of the layers you're joining decides. Add the shank overhang needed for spreading: the shank should be 2–3 mm longer than the material thickness.

The shank length is listed on each rivet's product page in the variants table as dimension B. The full range is in the Rivets & Screws category.

The hole diameter differs by material. For leather, choose a punch slightly smaller than the shank diameter: leather is elastic and grips the shank tightly. For waterproof webbing, choose a punch that matches the shank exactly; the webbing doesn't stretch, so the shank has to pass through without being forced.

A shank that's too long shows up as a rivet that deforms while spreading, or caps that don't line up.

Often bought together